GReddy Full Auto Timer, Инструкция по эксплуатации

Страница: 6 / 28

Harness Connections
Brown / Parking
do not use
Gray
not used
in the US
Turbo
Timer
2-pin connector
Purple / Speed
Parking Brake Feature:
(1)
Remove the cover over the parking brake and find the parking
switch wire(s).
(see you factory service manual)
(2) * If there is one wire, make sure the wire:
shows 0 volts, when the parking brake is engaged.
and shows 12 volts, when the parking brake is released.
* If there are two wires, find the wire that:
shows 0 volts, when the parking brake is engaged.
and shows 12 volts, when the parking brake is released.
(3) Route the Brown wire from the 2-pin connector to the parking
brake switch you found in (2).
(4) Connect the Brown wire to the wire found in (2)
(5) Replace the parking brake cover.
Speedometer / Auto timer Feature:
(Some vehicles do not have a speed signal to connect)
(1) Check your factory service manual for the proper speed signal wire.
(2) Access the speed signal wire on the ECU harness.
(3) Connect the Purple wire to the speed signal wire.
Note: This feature should only be attempted by a trained mechanic,
serious electrical damage can result form improper installation.
5
Shift lock
release uint
(for Japan only)
12V
0V