❏
8. Press a plastic z-bend clevis into each of the four
control horns. Trim the inside of the hole in the control horn
to ease the installation of the clevis.
❏
9. Glue a control horn into the underside of the elevator half.
Position the control horn as far forward as possible.
❏
10. Secure the back side of the control horn with a control
horn retainer. Secure it with a small bead of glue.
❏
11. Install a control horn into the right side of the rudder
using the same procedure.
❏
12. Install control horns in the underside of the ailerons
using the same procedure.
❏
13. If necessary, remove the servo arms from all of your
servos. Find 4 long output arms with the spline size that fits
your servos. Press a plastic z-bend clevis into the outer hole
on each of these arms. Trim the hole in the arm to ease the
installation of the clevis.
❏
14. Install the receiver and ESC into the fuselage. Plug
the servos into the receiver and temporarily install the
battery into the fuselage. Center all servos with your radio.
❏
15. Attach the servo arm to the elevator servo pointing
straight up. Secure the arm with the screw included with the
10
