❏
1. If necessary, extend the motor wires on your ESC so
that they are at least 8" [203mm] long.
❏
2. Pull the ESC output wires forward from the canopy and
out the hole in the firewall using the preinstalled string.
❏
3. Solder your ESC output wires to the motor. The positive
pole is marked by a red dot. Solder the wires to the same
point that the capacitors and brush wires are presoldered to.
❏
4. Slide the gearbox assembly onto the motor stick. Line
the hole in the gearbox up with the hole in the motor stick,
and secure it with a small wood screw.
❏
5. Install the prop saver onto the gearbox output shaft.
make sure that the screws seat down into the two flat spots
on the shaft.
❏
6. Install the cowl onto the nose. Secure it with 4 small
drops of hot melt glue. This will make it easy to remove if
needed for motor maintenance or replacement.
INSTALL THE PROPULSION SYSTEM
11
