GREAT PLAINS Yield-Pro YP4025A-48TR20, Руководство оператора

Страница: 40 / 190

2019-03-19 Table of Contents Index 411-198M
YP4025A-48TR20 Table of Contents Index Operating Instructions 36
Transport Checklist
 Plan the route. If towing a cart hitched to the product,
plan the route so that no reverse movements will be
necessary. Avoid steep hills. Keep Clearances in
mind. Folded, your implement name may be nearly
15 feet (4.6 m) wide and 13 feet (4 m) high.
 Hitch.
Make both electrical and hydraulic connections. See
“ Hitching Tractor to Product ” on page 17.
 If markers are unfolded, fold them.
See “ Folding the Markers ” on page 66.
 Raise product.
See “ Raising/Lowering Product ” on page 28
 Install lock-up channels on lift cylinders.
See “ Lift Cylinder Lock-Up ” on page 30.
 Disengage caster locks. See page 32.
 Fold and latch lower ladder section. See page 36.
 If product wings are unfolded, fold them.
See “ Folding the Implement Name ” on page 31.
Make sure wing locks are engaged.
 3-point hitch:
Lower hitch fully to ensure wings remain locked.
Hydraulic hitch:
Confirm CFM set to Hitch and hitch circuit in Float.
 Always have lights on for highway operation.
 Comply with all federal, state and local safety laws
when traveling on public roads.
 Travel with caution.
Loading Materials
Walkboard and Ladder
Walkboard pin and pivot operation is covered on
page 41.
Refer to Figure 31
The bottom two steps of the walkboard ladder are a
swing-down section. To release this section, pull the
spring-loaded pin
forward and pull the top of the free
end of the ladder back.
To re-stow the steps, merely swing them up and forward.
The spring-load pin automatically engages.
Machine Damage Risk:
Ladder steps must be locked up before lowering product or
machine damage will occur.
Figure 31
Walkboard Lower Ladder
29321
2
1
1
2