GREAT PLAINS Terra Max HT1110-6.0M, Руководство оператора

Страница: 8 / 42

Great Plains | 588-206M | 3/21/22 Table of Contents 4
HT1110-6.0M & 7.5M Table of Contents Safety Information
Transport Machinery Safely

NOTE: Maximum Transport Speed
Maximum Transport speed for implement is 30 kph
(20 mph). Some rough terrains require a slower speed.
Sudden braking can cause a towed load to swerve and
upset.
1. Comply with state and local laws.
2. Carry reflectors or flags to mark machinery in case of
breakdown on the road.
3. Keep clear of overhead power lines and other obstructions
when transporting.
4. Do not fold or unfold the implement while the tractor is
moving.
5. Do not tow an implement that, when fully loaded, weighs
more than 1.5 times the weight of towing vehicle.
6. Turning tractor too tight can cause implement to tip over.
7. When towing on a trailer, secure implement with tie
downs and chains.
8. When towing on a trailer, sudden braking can cause a
trailer to swerve and upset. Reduce speed if trailer is not
equipped with brakes.
Shutdown and Storage
1. Park the tractor and implement on a solid, level surface
where children normally do not play.
2. Raise the wings, put tractor in park or set park brake. Turn
off engine and remove switch key to prevent unauthorized
starting.
3. Wait for all components to come to a complete stop before
leaving the leaving the operator’s seat.
4. Turn lockout valve and wing lock levers to locked
position to prevent the wings from lowering.
5. Install transport lock onto lift cylinders then lower
implement on locks to relieve pressure on hydraulic
hoses.
6. Detach the tractor. Secure the implement using blocks.
Practice Safe Maintenance
1. Understand procedure before doing work. Use proper
tools and equipment. Refer to this manual.
2. Work in a clean, dry area.
3. Lower the implement. Put tractor in Park, turn off engine.
To prevent unauthorized starting, remove key before
performing maintenance or service work.
4. If work must be performed with wings raised, turn lockout
valve and wing lock levers to locked position.
5. Make sure all moving parts have stopped and all system
pressure is relieved.
6. Disconnect lighting harness from the tractor before
servicing or adjusting electrical systems.
7. Welding: Disconnect lighting harness from the tractor.
Protect hydraulic lines. Avoid fumes from heated paint.
8. Inspect all parts. Make sure parts are in good condition
and installed properly.
9. Do not alter this machine in a way which will adversely
affect its performance.
10. Remove buildup of grease, oil or debris.
11. Remove all tools and unused parts from implement before
operation.