GREAT PLAINS TCN5107, Руководство оператора, Страница: 43 / 78

TCN5107-5313 Table of Contents Index Operating Instructions
Great Plains | 566-170M | 04/26/2019 Table of Contents Index 37
Perform all steps in “ Pre-Start Checklist ” on page 24 and
“ Final Field Checklists ” on page 36.
Do not make short radius turns with the implement in the
ground.
 If you stop in the middle of a pass, raise the implement
and back up 3m (10 ft) before resumption of tilling.
First Time Field Adjustments
Pre-Leveling of Machine
 Pre-leveling of machine should be done on a good
level surface.
Front to Rear Leveling
Refer to Figure 29
1. Lower the machine until the front row of shanks are 1 to 2”
above the surface. At this point, remove the snap wire pin
from the turnbuckle lock , swing lock off turnbuckle and
adjust the hitch turnbuckle to adjust the fore and aft. The
front corner of the main frame should be 1/2 to 1” lower than
the rear corner.
2. Now the turnbuckle lock may be swung back onto hitch
turnbuckle and the snap wire pin may be re-installed.
3. If machine needs leveled from front to rear when running in
field, remove the snap wire pin from the turnbuckle lock
, swing lock off turnbuckle and adjust the hitch turnbuckle
. When done adjusting, be sure and swing turnbuckle lock
back down and secure with snap wire pin.
First Pass Operation Checklist Page
1.
Implement unfolded and aligned for first pass, with
coulter disks about 3m before field edge.
25
2. Pull forward, lower Turbo-Chisel, and begin tilling
for a short distance.
3.
Stop. Assess:
•
coulter depth
•
shank depth
•
finishing attachment operation
4.
Make necessary adjustments 37
Sharp Field Turns Checklist Page
1.
Raise Turbo-Chisel 30
2.
Make turn
3.
Lower Turbo-Chisel 3m before field edge 29
4.
Resume tilling.
Ending Tilling Checklist Page
1.
Suspend operations as above, then
2.
Lift implement
3.
Set tractor for fold 26
4.
Fold wings
26
5.
Place locking valves in transport position 29
6.
Place transport locks in transport position
7.
Lower implement on to transport locks
8.
Lights ON for transport
Figure 29
Hitch Turnbuckle Adjustment
41805
3
1
2
1
2
3
2
3 1
1
2
3