GB - 30
COOLING SYSTEM (992113, 117, 121, 123, 124,
125, 126, 130, 134, 135, 136, 137, 138, 139)
Checking Coolant Level
Check coolant level when
engine is cold. Check coolant
level at overflow reservoir.
1.Place unit in the service
position (see SERVICE
POSITION on page 20).
2. Check coolant reservoir.
Coolant should be between
the low and full marks with
engine cold.
3. If coolant is below the low
mark, remove cap, and add
coolant to the full mark. Refer
to Engine Manual for the
correct type of coolant.
Changing Coolant
Refer to Engine Manual for the correct procedure on when
and how to change the coolant.
SHORT TERM
NEVER spray unit with high-pressure water or store unit
outdoors.
Inspect unit for visible signs of wear, breakage or damage.
Keep all nuts, bolts and screws properly tightened and know
unit is in safe working condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low pressure water
and lubricate (see LUBRICATING UNIT on page 21). Touch
up all scratched painted surfaces.
Remove weight from wheels by putting blocks under frame
or axle.
When storing unit for extended periods of time, remove all
fuel from the tank, start up the engine, and run the unit out of
gas. Refer to Engine Manual.
Clean and charge the battery. Charge battery every three to
four weeks when storing unit.
WARNING: To avoid personal injury DO NOT
remove radiator cap when engine is hot. Check
coolant level at coolant reservoir, not at radiator.
F
ULL
LO
W
OF3226
2
3
1. Operating Range
2. Full
3. Low
1
STORAGE
WARNING: AVOID INJURY. Read and understand
entire Safety section before proceeding.
