43
44
◆ A High Output-Volt error message indicates that
either the out voltage setup exceeds the requirements
for the charging/discharging battery or the number of
cells has been improperly selected.
◆ A Temp. Sensor error message indicates that the
temperature sensor either is plugged in “backwards”
with the positive to negative connections inverted or
has a fault inside the sensor.
◆ A Bat. Temp Too Low error message indicates that
the battery temperature is too low to operate using the
charging process.
◆ A Bat. Temp Too High error message indicates
that the he battery temperature exceeds the preset
temperature values.
◆ An Internal Temp. error message indicates that
the internal temperature within the charger ex-
ceeds the recommended operating conditions.
◆ A BLC Volt High error message indicates that
the balancer cell voltage exceeds the recom-
mended operating conditions.
◆ A BLC Volt Low error message indicates that
the balancer cell voltage is below the recom-
mended operating conditions.
◆ A Calibration error message indicates that threre
is a fault in either the default calibration data or the
internal circuits of the charger.
◆ A No Sensor error message indicates that
the temperature sensor has been disconnected.
◆ A Connection error message indicates that the
preset number of cells and the detected number of
cells are different.
◆ A Motor Current error message indicates that
the operating current exceeds the value in the
MISC MOTOR function.
◆ A Balancer Port error message indicates that
the balance connector has been disconnected.
◆ A Low Output-Volt error message indicates that
either the voltage setup is below the requirements for
the charging/discharging battery or the number of cells
has been improperly selected.
◆ A Sync. Command error message indicates that
the preset number of cells and the number of cells
of CH1, CH2 are not matched to the values entered
into the Charge/discharge and Sync modes,
Low Output-Volt
BLC Volt Low
High Output-Volt
Calibration
Internal Temp.
Motor Current
Temp. Sensor
No Sensor
BLC Volt High
Balancer Port
Bat.Temp Too High
Bat.Temp Too Low
Connection
Sync. Command
Output voltage is lower
than the selected cells
or voltages.
Pls select proper cells
or voltages.
Balancer cell voltage is
too low !
Low cell is [0]
Output voltage is higher
than the selected cells
or voltages.
Pls select proper cells
or voltages.
Either calibration data or
internal circuit might
have been damaged.
Internal temp is too hot!
Contact Hobby Services
if this message appears
often.
Pls reconnect the moto
rand restart !
A temperature sensor is
connected in reverse or
is defective.
A temp-sensor is not
connected to the port.
Pls connect the sensor
to the port then restart!
Balancer cell voltage is
too high !
Over cell is [0]
BLC Port is opened.
Pls check the BLC port.
Battery temp is too high
to be operated !
Battery temp is too low
to be operated !
Selected cells and
cells connected to the
balancing port are
different !
Pls recheck and restart!
Sync order failed.
Error occured in the
counterpart channel !
