GRAUPNER PEP 4318, Руководство пользователя

Страница: 14 / 20

14 / 20
4318_PN_V1
Assembly step 12
Insert the prepared tail units
into the fuselage and align
them exactly, place the wing
(35) on the fuselage for con-
trol, sight from the front
whether the rudder is verti-
cal and the elevator is paral-
lel to the wing. If necessary,
check with a triangle ruler
placed on the wing. If all is
correct, as shown, apply a
few super glue in all corners
between the fuselage and
tail. The assembly of the
fuselage is complete.
Assembly step 13
Glue the reinforcement (36)
to the end edge of the wing
(35). Fix the strip (36) from
below with adhesive tape on
the wing without gaps. Then
tilt the bar slightly down-
wards and apply super glue
from the top, close it again
and immediately wipe off
the excess adhesive. Mark
the center line on the top
and bottom with a soft pen-
cil, never press down firmly.
Assembly step 14
Place the wing centered on
the fuselage and align it at
right angles by means of a
square triangle. Then fix the
wing from the top with four
fixing needles. Open the flap
(2) and screw in the screws
(50) from below until they
impress a mark on the wing.
Remove the wing and
unscrew the screws (50).