GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical modifications reserved.
09/2011
7
•
Attach the jib to the jib boom. Tie the cord at the tack [f1] permanently to the eye on the forward jib boom
swivel bracket, then screw the clew [e1] permanently to the clamp bracket.
•
Connect the two loops in the forestay to the small hole in the rigging eye at the mast swivel bracket. Adjust
the position of the shroud tensioner to the point where the foot [c1] and the foot [c2] of the two sails are
approximately in line. Now wrap the forestay round the weighted shaft, tie it, and secure the cord with a
drop of cyano. Locate the loop in the topping lift [F] and connect it to the small hole at the same time.
•
Run the loop in the forestay [H] into the small eye, fit the cord through the eye on the opposite side, and
then into one of the holes in the annular clamp. Insert a loop of the cord in the opposite hole, then tie the
cords together lightly. Position the shroud tensioner centrally between the two eyes, tighten the knot fully,
and secure the knot with a drop of cyano.
•
The whole rig should now be placed under tension in
such a way that the mast curves slightly towards the
stern. Use the two clamp brackets to adjust the sails
so that they adopt a slight belly under wind pressure.
Adjust the depressor on the main boom in such a way
that the sail is smooth and free of creases, then
tighten the locknut to maintain this setting.
