GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical modifications reserved.
09/2011
5
•
Insert the keel in the hull, and tighten the retaining
nut at the top; it should only be hand-tight.
•
To form a connection between the transmitter and
the receiver, the receiver must be bound (see fol-
lowing section ‘Binding’). Fix the end of the aerial to
the edge of the deck opening with a piece of ad-
hesive tape.
•
Check that the blocks on the sail setting lever are attached to the inner holes; unscrew and re-fix them if
necessary. The blocks must be free to move on the lever. If you have to make any changes, take care not
to twist the two sheets (see sketch).
•
Insert the main boom, the swivel bracket and the aluminium tube in the opening in the deck.
•
Fit the mast in the opening in the main boom pivot.
•
Locate the loops in the shrouds [E] and the backstay
[D], slip them through the small holes in the figure-of-
eight rigging eyes, then place all three under light
tension.
