GRAUPNER HoTT GR-12L S1012, Руководство пользователя, Страница: 12 / 20

12 / 20
S1012_GR-12L_DE_V1sh
Se tting and displ ay of the receiver se ttings
The receiver-side menus can be viewed and some times changed
using a suitable HoTT transmi tt er or the SMART-BOX. You can find
out how to open the menus of a receiver in the "Telemetry" section
of the corresponding manual as well as a detailed descrip tion of the
receiver menus on the r especti ve product page at www.graupner.
com on the Internet.
Note
The values shown in the following display illustra tions always show
the standard values.
Display "RECEIVER"
ALARM VO L T
• If "SERVO" or "SENSOR" is visible in the "CH5 FUNCTION" line
described below, the opera ting voltage of the receiver is moni-
tored via the limit value set in the v alue field of "ALARM VOLT".
• If "BATT-V" is visible in the "CH5 FUNCTION" line described below,
the opera ting voltage of the drive ba tt ery connected via "BATT-V"
is monitored via the limit value set in the value field of "ALARM
VOLT".
In both cases, the actual voltage is shown in the transmi tter's display
in the "Receiver voltag e" field.
If the voltage drops under the set limit value, a transmi tt er-side
alarm takes place in the form of an acous tic signal (interval beep long
/ short).
Adjustment range: 2,5 … 22,5 Volt in 0,1 Volt steps.
ALARM TEMP
This op tion monitors the receiver temperature. If the set limit is
exceeded, a transmi tt er-side alarm takes place in the form of a con-
tinuous beep.
Adjustment range: 30 … 80 °C
PERIOD
In this line, specify the periods for the individual channel pulses. This
se tting is t ransferred for all control channels.
If your system is used exclusively with digital servos, you can set a
cycle time (frame rate) of 10 ms. If your system includes some or
uses exclusively analogue servos, always select 20 ms since the ana-
logue servos may be overloaded and respond by "ji tt ering" or "growl-
ing".
Adjustment range: 10 or 20 ms
TELEMETRY
SETTING & DATA VIEW
SENSOR
DISPLAY RF STATUS
SELECT ANNOUNCE
RX DATA ON
ALARM SETTING
RECEIVER 2.05
ALARM TEMP: 65°C
ALARM VOLT: 3.7V
CH5 FUNCTION:SERVO
PERIOD: 20ms
RSSI CH : OFF
CH6 FUNCTION:SERVO
F.RESET : No