Operation
16
Operation
Error message „Check Battery“
The error message
„Check Battery“
appears when the individual cell voltages differs over 0.2 V.
This is an indication that the connected battery may be defective. In this case check your battery
immediately!
If this message appears, the balancing- or discharge process will not start!
Appear triangle
one or more
（
）
＂
＂
Check Battery
is flashed
Check
Battery
Receiver battery check
The balancer can also be used to check the actual voltage of any battery (with JR or Futaba) with a
voltage between 1.2 and 12 V DC.
Plug the battery into the JR connector on the bottom of the balancer.
Pay attention to the polarity!
In this mode, no single cell display is available!
Note: when checking batteries under 4.8 V an additional power supply (7.4 - 11.1 V DC) must be con-
nected to the socket „JST“ to enable the display.
S
JST
Rx Batt
．
External power
7.4 - 11.1 V DC,
BEC connector
Receiver battery
1.2 - 12 V,
JR connector
