TO LIGHT AND OPERATE
WARNING:
If the flames
are found to be extinguished
and the control
is not in the OFF position,
the control
knob should
be returned
to
the OFF posit
i
on
and no attempt
should be made to light the gas until at least 3 minutes
have elapsed
.
SAFETY
The fire is fitted with a flame supervision
device
which will shut off the gas supply iffor any reason the pilot goes out
.
The control
knob is located
behind
the fender
ash-pan
door
.
Depress
the control
knob and rotate to the PILOT / IGN position
until the
ignition sparks
.
If the pilot did not light return the control knob to the OFF position and try again
.
Once the pilot is l
i
t keep the control
knob
pushed in for a further
10 seconds
before releasing.
The pilot should remain lit
.
Refer to Fig
.
7 for viewing
ofthe
pilot when lit
.
When the pilot is established,
Turn the control
knob to the HIGH position
.
Your fire is now operating
on full heat input
.
You may now turn
the control knob to the LOW position
if desired
.
HEAT SETTINGS
There are two heat settings HIGH and LOW (see Fig 3). Setting LOW
i
s the lowest sett
i
ng and
gives gas at a min
i
mum rate to the burner
58083
