GRASS VALLEY KAM-ENC-2AES, Инструкция по эксплуатации

Страница: 35 / 76

KAM-ENC-2AES Instruction Manual 35
KAM-ENC-2AES Links and Web Pages
View Selection
In the View Selection display, choose the
Standard
radio button to display
the standard settings shown in Figure 17 on page 34 . Use the
Advanced
view
for configuring the Vertical Blanking Interval for selecting active video
lines to carry data (see
Advanced VBI Configuration on page 36 ).
Video Selection Settings
The following functions are provided in the Video Selection section in both
the Standard and Advanced views:
• Input Name – (read-only) signal name is entered on the I/O Config web
page
• Input Status –
• Signal presence reported
• Enable/disable Loss of Signal report to both Kameleon status web
pages and SNMP monitoring devices.
Note The disabling of video and reference Loss of Signal reports and SDI Input
Error warnings allow you to filter reports from higher level Kameleon status
displays and SNMP monitoring. They will still be reported on this web page.
• Video Format – current input video format reported.
• Video Line Rate – select 525 or 625 line rate or enable automatic line rate
detection
• Frame Reference –
• 2000GEN frame reference signal presence reported,
• Enable/disable Loss of Signal report to both Kameleon status web
pages and SNMP monitoring devices.
• SDI Input Errors –
• Input signal errors reported, and
• Enable/disable SDI error warning report to both Kameleon status
web pages and SNMP monitoring devices.
• Frame Sync/Delay – (read-only) Frame Sync mode is reported when
Output Timing Selection is
Internal Frame Reference
and timing is pro-
vided from the 2000GEN module. Frame Delay mode is reported when
the input signal (
Video In
) is used for timing reference.
Output Timing Selection
The 2000GEN reference module must be installed in the frame and for the
Kameleon to work as a frame synchronizer, set the output timing source to
Internal Frame Reference
. Otherwise, set the output timing source to
Video In
.