GRASS VALLEY KAM-ENC-2AES, Инструкция по эксплуатации

Страница: 30 / 76

30 KAM-ENC-2AES Instruction Manual
KAM-ENC-2AES Links and Web Pages
Header Row
The top header row provides the connector hardware physical label (J#)
and the dedicated signal type for the connector. This information is deter-
mined by the type of rear module and front processor module installed
(refer to the
Functional View Web Page on page 31 ).
Connectors
The connector row illustrates connector type provided (BNC or 3-pin ter-
minal) for each port. For this rear module, one SDI video input, two digital
audio outputs, and one composite video output are provided.
Input/Output Mode
I/O mode is either static read-only or an operational Input/Output selec-
tion (determined by the rear module used).
Signal Name
Enter a signal name (up to 15 characters) for each operational
input/output. The name will be used to identify the signal in other config-
uration web pages. Factory default names are shown in
Figure 12 on
page 28 and Figure 13 on page 29 .
Status
Table 4 shows, by color and signal type, the signal status reports that may
be displayed in the Status row for this module configuration:
Table 4. I/O Config Status Report Messages
Color Video In Analog Audio In Analog Audio Out Digital Audio In Digital Audio Out Video Out
Green Present None None Present None None
Yellow
Not present or
525/625 mismatch
None None Not Present None None
Light Grey None None None None Not Monitored Not Monitored
Medium Grey None None None Not Available Not Available None
Dark Grey None None None None None None