GRASS VALLEY Kaleido-IP X110, Быстрый старт

Страница: 25 / 47

13
Kaleido-IP X310/X110
Quick Start Guide
17 Click OK .
18 If this Kaleido-IP is meant to monitor HLS sources, then you must also configure access
to your facilities’ DNS, and proxy servers:
a Click Configure , under DNS and proxy configuration .
The DNS and Proxy Configuration page appears.
b Type the appropriate suffixes for your primary domain, and search domain, and the
IP addresses for the primary, and secondary DNS server.
c Select Enable proxy , and then type the URL of the appropriate proxy auto-config
(PAC) file, if required.
d Click Apply configuration .
A message appears confirming that the changes have been applied.
e Click OK to dismiss the message.
19 If this system must monitor sources from a VLAN environment, then refer to Configuring
Virtual Network Adapters on a Kaleido-IP , in the Kaleido-X User’s Manual, to add the
required virtual network adapters.
Finding the Management IP Address and Application Version
To find the management IP address and application version
1 Connect a mouse to a USB connector: either at the front of the frame, or on the rear
panel.
2 Right-click anywhere on the monitor wall. On the shortcut menu, point to Monitor Wall
(if you clicked a monitor), and then click Show dashboard to display the dashboard
associated with the current head. A small window appears in the bottom-right area,
revealing the management IP address and the system version. Take note of these
values.
Note:
Settings cannot be applied to a multiviewer system while an
upgrade is in progress. If the multiviewer does not reboot after 10 seconds
or so, try clicking
Apply settings again after a minute or two, until the
multiviewer reboots.