GRASS VALLEY IQMIX25 Series, Руководство пользователя

Страница: 84 / 98

84
RollCall Control Panel
Logging - Spigot
Brought into line with UCP V16.0
The following options are available. Enable check boxes to activate log fields as required.
Note: If spigots are linked for UHD traffic, only the Master spigots are shown
on the main menu. Slave spigots are not shown.
Log Field Description
INPUT_ N _IDENT= System-defined identifier for the input, based on the rear
ID.
INPUT_ N _NAME= Name of the input, as defined by the user on the Setup
page. See Setup on page 91.
INPUT_ N _STATE= Valid values are:
• OK : input signal good.
• FAIL : input signal not detected.
INPUT_ N _TYPE= HD/SD/3G SDI
INPUT_ N _STANDARD= PAL/NTSC/625 Mono/525 Mono
INPUT_ N _STREAM= Not to be used if the spigot is part of a UHD Quad-Link
configuration. Use INPUT_
N _LINK_ M _

STATUS= in this case (see below).
Displays whether an IP sender uses SDI on Primary,
Secondary or both. Valid values are:
• Dual - both used.
• A - only Primary used.
• B - only Secondary used.
INPUT_ N _LINK_ M _

STATUS=
Reports the status of an input when it is used as a QL UHD
link. Valid values are:
• OK: Linked
• OK: Not Linked
• FAIL: No Input
• FAIL: Wrong Standard
OUTPUT_ N _IDENT= Name of the output as shown on the rear panel.
OUTPUT_ N _NAME= Name of the output as defined by the user.
OUTPUT_ N _STATE= Valid values are:
• OK - output signal good.
• FAIL - output signal not detected.
• WARN:Freeze
• WARN: Pattern
• WARN:Black