GRASS VALLEY Ignite JSC-2300 SHOT, Инструкция по эксплуатации

Страница: 42 / 66

42 Ignite JSC-2300 SHOT Director Robotics/Camera Controller Instruction Manual
Section 3 — Installation and Setup
6. Rotate the
MANUAL IRIS
knob and verify that it operates smoothly for
several rotations in each direction. Verify that the
IRIS
numerical
display on the
DIAGNOSTICS
dialog box changes with the rotation of the
knob.
Note The following step refers to the grid in the lower left corner of the DIAGNOS-
TICS dialog box.
7. Verify that a corresponding box highlights when pressing:
• Each button on the controller (except the Power button)
• The button on top of the joystick
8. Select
OK
.
Set Audible Alarm (Optional)
Note By default, the audible alarm ( BEEP ) is set to ON (checked box) with the pitch
set to 20 (mid-range).
1.
Press the
Setup
button ( Figure 8 ). The
MAIN SETUP MENU
dialog box
( Figure 15 ) appears.
2.
Select
SHOTDIRECTOR SETTINGS
( Figure 15 ). The
SHOT DIRECTOR SETTINGS
dialog box ( Figure 21 ) appears.
3.
To turn off the audible alarm, use the joystick to uncheck the
BEEP
checkbox ( Figure 21 ).
4.
To change the
BEEP
pitch, use the joystick to select the pitch box
( Figure 21 ), type in a number from 0 to 40, and press the keypad
enter
button ( Figure 10 ).
5. Select
OK
.
Reassign Camera Quick Select Buttons (Optional)
Note By default, Camera Quick Select buttons ( Figure 8 ) are set to CAM1 through
CAM4. There are only four Quick Select buttons, so assign them to the four
most frequently used cameras.
1.
Press the
Home
button ( Figure 8 ). The
CAMERA CONTROL
Home dialog box
( Figure 13 ) appears.
2.
To erase the current camera entry, press and hold any Camera Quick
Select buttons (
Figure 8 ) for three seconds.