GRASS VALLEY FGAEY 1312, Руководство пользователя

Страница: 54 / 71

MV-801 User Manual
Issue 1 Revision 1 Page 34
4. Now move to the front of the router.
5. Unlock and open the router front door and

open the relevant internal fan door (refer to Figure 14).
Front module removal:
6. Remove all front modules from front slots that need to be emptied.
Remove a front module by pulling on the two module eject levers and sliding the
module out of the frame.
7. Close and secure the internal fan door.

Close and lock the router front door.
All relevant slots should now be empty, front and rear.
8. Continue immediately to read Section 3.4.3 Fitting Preliminaries , on page 34 before
starting Module Fitting Procedure , on page 36.
3.4.3 Fitting Preliminaries
Figure 19 Removing Front Modules, showing use of module eject levers
Remove
Note: The slot labeling nomenclature used in Figure 15, Figure 16 and
Figure 17 (on pages 27, 28 and 29) is used in this section to identify the
slots. Thus, for example, front Slot (1) refers to the front slot labeled (1)
in the figures, etc.
IMPORTANT Electrostatic Damage
Static precautions must be observed when handling, inserting or
removing modules.
Note: Rear module fitting requires:
• A Pozidriv screwdriver
• Two pan head, M3 x 6 mm, zinc plated screws per rear module.
IMPORTANT
When inserting a module - Take care not to knock high
components which are mounted on the top- or on the under-side
of the module.
Any knocks may damage the module being inserted, or the
modules above and below it in the router frame.