GRAPHTEC WR3320A, Руководство пользователя

Страница: 20 / 50

2.1.3 Loading Z-Fold Paper
it with the right hand counter-
clockwise to remove it.
●
Next, insert the roller shaft
into the hollow shaft of the
paper roll, check that the nut
comes out the other end, and
then screw on the flange just
removed from the shaft to fix
the paper roll on to the shaft.
④ Hold the roll so that the gear is
to the right as shown in Fig. 2-2,
then with one hand place the roll
in the Linearcorder
① Remove te roller shaft as described
above in the procedure for loading
roll paper. (The roller shaft is not
repuired when Z-fold paper is
loaded.)
② Set the roll paper/Z-fold paper
switch to Z FOLD.
③ Open the cover of the Z-fold paper
box as shown in the illustration
below, and now load the paper as
shown in Fig. 2-3 above. (Insert
the paper so that channel 1 is
on the left-hand side.)
It is a good idea to open the front
panel and then insert the paper.
It will be easier that way.
Once the paper is loaded, use the
following procedure to set the paper
in the Linearcorder.
① Pull the pen life lever forward, so
that the sprocket roller can be
rotated freely. Take the front end
of the paper in both hands and
draw it over the top of the plate,
passing it through the space bet-
ween the sprocket rollers. Once
2.1.4 Paper Setting
Note The roll paper/Z-fole paper
switch must be set to Z FOLD.
Fig. 2-3 Loading Z-Fole Paper
-14-
Cut open the lid of the Z-fold paper box and load
(from front cover)
Fig. 2-2 Loading Roll Paper
Sprockert roller
Plate
Insert paper
into this gap
Cut paper edge
in trapezoid
Support from
underneath
Must be set to STOP