GRAPHTEC LABELROBO LCX603, Руководство по установке

Страница: 71 / 122

LCX603-UM-651-9370 2-63
2 Setup
2.18 Distance Adjustment
This adjustment should be performed after the different thickness of media was installed.
The distance adjustment compensates for the length of the plot line generated according to the thickness
and type of the media used. As for the distance adjustment value, the length of the line is measured and
entered.
The adjustment pattern is printed, and the correction value is entered as the distance adjustment.
Measure the distance between crosses printed with Head 3 (ribbon 3), and enter the correction value as
Correction Value = Measured Value - 190 mm.
The adjustment pattern outputs two layers. Measure the printing results, and enter the correction value.
Also, printing the distance removed data in the direction of the media feed, when setting the distance
adjustment value, refer to the User Pattern Correction printed below.
The 130 mm width media have to be installed when performing the distance adjustment.
And the ink ribbons have to be installed for all print heads.
Adjustment Pattern Instructions
Y
X
First page
Second page
Y
X
Head 1 (Ribbon 1): Blue
[Example]
Head 2 (Ribbon 2): Red
Head 3 (Ribbon 3): Black
Head 1 (Ribbon 1): Blue
[Example]
Head 2 (Ribbon 2): Red
Head 3 (Ribbon 3): Black
Printed with head 3
Printed with head 3
Printed with head 2
Measure the length
Measure the length
Printed with head 1
Feeding direction
Feeding direction
Wrinkle
prevention
lines
Wrinkle
prevention
lines
Print 4 cross sections with Head 3. Print the connecting line segment with Head 1 in the first layer, and
Head 2 in the second layer.