LCX603-UM-651-9370
2-58
2 Setup
(4) Perform a check of the cut pattern. Peel the square section of the test pattern exterior and observe
the triangular corner section in the middle. If the corner sections are round, the correction amount
(offset) is lacking. By contrast, if there are sharp whisker-like areas in the corner sections, the offset is
too high.
Correction amount
is too low, increase
the offset value.
(+1 to +5)
Adequate offset value.
Correction amount
is too high, decrease
the offset value.
(-1 to -5)
Peel the triangular section and the remaining thinly cut traces in the backing sheet will be just the right
cutting force. In cases where the backing sheet has been fully cut, the cutting force is too high or the
blade length is too long. In cases where cutting traces are not present in the backing sheet, the cutting
force is too low or the blade length is too short.
Peel the triangular section and the remaining thinly cut traces in
the backing sheet will be just the right cutting force. In cases
where the backing sheet has been fully cut, the cutting force is too
high or the blade length is too long. In cases where cutting traces
are not present in the backing sheet, the cutting force is too low or
the blade length is too short.
(5) Press the F1 key (TOOL CONDITIONS) and adjust the cutting force/correction amount (offset) in the
condition setting menu.
(6) Repeat steps (2) - (5) until a favorable cut has been achieved.
(7) If a favorable cut has been achieved, press the ESC key to return to READY status.
Содержание LABELROBO LCX603
Страница 2: ......
