Graphite 58G792, Инструкция по эксплуатации

Страница: 13 / 96

13
Switch lock button 6.
Switch 7.
* There can be differences between the drawing and real product.
DESCRIPTION OF USED GRAPHIC SIGNS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
Tip for tightening - 1 pcs. 1.
Carry case - 1 pcs. 2.
PREPARATION FOR WORK
FASTENING WORKING TOOLS
●
Loosen the quick coupling chuck ring ( 1 ), until a required opening of jaws is obtained, allowing to
insert a drill bit or screwdriver bit.
Insert the working tool sliding it all the way to the quick coupling chuck (
●
1 ) and fasten it tightening
the loosened ring.
The working tool is removed in the reverse order to the installation.
●
If a new drill bit or screwdriver bit is installed, once the tool is started, observe the tool for excessive play,
which may be prove of an incorrect fastening in the quick coupling chuck.
OPERATION / ADJUSTMENTS
SWITCHING ON /SWITCHING OFF
The mains voltage must correspond to the value specified on the tool nameplate.
Switching on - press the switch button ( 7 ) and hold in this position.
Switching off - release the pressure on the switch button ( 7 ).
The switch lock (continuous operation)
Switching on:
Press the switch button (
●
7 ) and hold in this position.
Press the switch lock button (
●
6 ) ( fig. A ).
Release the pressure on the switch button (
●
7 ).
Switching off:
Press and release the pressure on the switch button (
●
7 ).
SPEED ADJUSTMENT
The drilling or tightening speed can be controlled during work by increasing or decreasing pressure on
the switch button ( 7 ). The speed control allows for slow start, which helps to maintain working comfort for
loosening and tightening.
TORQUE ADJUSTMENT
The setting of the torque control ring ( 2 )to a selected position locks the clutch to a specified amount of
torque. When the set amount of torque is reached, the overload clutch will be automatically disconnected.
This prevents from overtightening of a screw or damaging the tool.