Graphite 58G605, Инструкция по эксплуатации

Страница: 12 / 96

12
EQUIPMENT AND ACCESSORIES
Drill chuck + key - 1 pce 1 .
Au x iliary handle - 1 pce 2 .
Additional handle - 1 pce 3 .
Depth gauge rod - 1 pce 4.
He x agonal key - 1 pce 5 .
Flat spanner - 2 pcs 6.
Reducer sleeve - 1 pce 7 .
Transport case - 1 pce 8 .
PREPARATION FOR OPERATION
INSTALLATION OF THE HANDLE
Due to personal safety issues it is recommended to use the additional or auxiliary handle.
INSTALLATION OF AUXILIARY HANDLE
Au x iliary handle is used when the tool operates in mi x er mode .
t
Loosen screws on the mi x er drill body .
Slide the au x iliary handle rod ( t 8 ) into the hollow in the mi x er drill body ( fig. A ) .
Tighten loosened screws to secure the au x iliary handle . t
Deinstallation of the au x iliary handle is similar to installation, only the sequence of actions is reversed .
t
INSTALLATION OF MIXER
Install reducer sleeve ( 7 ) on the mi x er drill spindle ( 6 ), tighten with flat spanners (included) ( fig. B ) .
Screw the mi x er shaft into the reducer sleeve ( t 7 ) .
INSTALLATION OF ADDITIONAL HANDLE
Additional handle is used when the tool operates in drill mode .
Possibility to rotate the additional handle ( 2 ) before it is clamped on the mi x er drill body allows choosing
the position most comfortable for specific working conditions .
t Loosen the wheel lock that locks collar of the additional handle ( 2 ) by turning it left .
Slide the additional handle collar over cylindrical part of the mi x er drill body . t
Turn for the most comfortable position .
t
Turn the handle lock tight to the right to clamp the additional handle . t
DEPTH GAUGE INSTALLATION
Depth gauge ( 5 ) is used to limit the depth of drill penetration of material .
Loosen the wheel lock, which blocks collar of the additional handle ( t 2 ) .
Slide depth gauge rod (
t
5 ) into the hole in the additional handle collar ( 2 ) .
Set desired drill depth . t
Fi x by tightening the additional handle wheel lock . t
DRILL CHUCK INSTALLATION AND REMOVAL
Drill chuck is fi x ed directly on the mi x er drill spindle .
Open drill chuck ( t 1 ) jaws .
Unscrew the drill chuck fi x ing screw with cross screwdriver, by turning it clockwise (left-hand thread) .
t
Install he x agonal key in the drill chuck ( t 1 ) ( fig. C ) .
Hold the spindle with flat spanner and gently tap the end of the he x agonal key . t
Unscrew the drill chuck .
t
Installation of the drill chuck is similar to deinstallation, only the sequence of actions is reversed .
12