Graphite 58G127, Инструкция по эксплуатации

Страница: 15 / 112

15
Check position of the tool when installing drill or driver bit in the chuck. Use additional magnetic
adaptor as an extension when using short driver bits.
LEFT – RIGHT DIRECTION OF ROTATION
Choose direction of spindle rotation with the selector switch ( 3 ) ( fig. F ).
Right rotation – move the switch ( 3 ) to the extreme left position.
Left rotation – move the switch ( 3 ) to the extreme right position.
* The possibility is reserved that in certain cases position of the switch relating to rotation direction may be different than
specified. Please refer to graphic signs placed on the switch or tool body.
Safe position of the selector switch ( 3 ) is the middle position. It prevents accidental starting the power
tool.
Drill cannot be started, when the switch is in this position.
●
Use this position of the switch to change bits.
●
Check if the position of the selector switch (
●
3 ) is correct before starting the tool.
Do not change direction of spindle when the spindle is rotating.
CHANGE OF GEAR
Gear switch ( 7 ) ( fig. H ) allows to increase the range of rotational speed.
Gear I: small speed range, big torque
Gear II: wider speed range, small torque.
Set the gear switch in position appropriate for the works to perform. When the switch is blocked and cannot
move, turn the spindle slightly.
Never change the gear switch position when drill driver is operating. It may damage the power
tool.
Long lasting drilling at low rotational speed of the spindle may cause motor overheating. Provide
periodic breaks during operation or let the tool operate at maximum speed with no load for
approximately 3 minutes.
OPERATION AND MAINTENANCE
QUICK RELEASE CHUCK REPLACEMENT
Quick-release chuck is screwed onto spindle of the drill driver and additionally secured with a screw.
Set the direction selector switch (
●
3 ) in the middle position.
Open jaws of quick release chuck (
●
1 ) and unscrew the fixing screw (left-hand thread) ( fig. H ).
Install hexagonal key in the quick release chuck and tap the other end of the key.
●
Unscrew the quick release chuck.
●
Installation of the quick release chuck is similar to deinstallation, only the sequence of actions is
●
reversed.
All faults should be repaired by service workshop authorized by the manufacturer.
TECHNICAL PARAMETERS
RATED PARAMETERS
Drill
Parameter Value
Voltage 18 V DC
Type of battery cells Ni-Cd
Battery capacity 1500 mAh
No load rotational speed 0-350 / 0-1000 min
-1