6
3.5
Mounting the rack
You need a second person to mount the rack!
1) Remove the cross profile (1) and attach the enclosed castors with locking device (2) to the plates provided.
16x M8 (black) with washer and nut
2) Lock the wheels (2) by applying the parking brake.
ATTENTION! The screws are screwed from the outside on each shelf. This means
that the head of the screw lies in the shelf and the cap nut is screwed onto the
screw from the outside.
3) Remove the narrow base (3) with the 4 holes.
4) Fasten this base (3) first through the 2 outer holes with the cross profile. 8x
screw M8 x 70
5) To give the rack more stability, now mount the 4 stiffeners (11) on the frame.
6) Then take the short lug (4) and fix the lower hole of the bottom (3) with the crossbar (1) and the lug (4).
7) Now take the wide longitudinal profile (5) and place it between the tab (4) and the shelf (3). Ensure that
there is only one hole on the underside and 2 holes on the opposite side! Afterwards you can also fix the
screw here from the inside to the outside through the profile and the tab.
8) Carry out steps 4 - 6 also for the opposite side and place the shelf on the locked castors (2)!
9) In the next step, fix the next shelf (6) from below. 2x M8 x 75 / 2x M8 x 65
10) The stiffeners (11) are also fixed in the lower screw (M8 x 75).
11) Now remove the narrow longitudinal profile
(7) and insert it into the wide longitudinal
profile (5) from above. Ensure that the holes
match the existing holes in the wide
longitudinal profile (5).
12) Now lift the next shelf (8) to the height of the
holes and screw it to the two profiles (5 + 7).
4x M8 x 65
13) Now you can attach the two wide shelves
(9 + 10) to the narrow profiles (7). 4x M8 x
55 for each shelf
! ATTENTION! The warning notices and the
shelf and rack carrying payload limit stickers
are attached to the side of shelf 10.
14) The upper profile (7) now has 2 holes for the
enclosed handles (12). Mount the handles
(12) here with the cap nuts facing inwards. 4x
M6
