5
3
Mounting the rack
3.1
Foreword
Before removing from the packaging, assembly instructions must be read and followed exactly. Improper
assembly will lead to exclusion of liability and warranty. Please note that there is a risk to life and limb in
the event of incorrect installation. Wilhelm Fricke SE assumes no liability, guarantee or warranty for prod-
ucts and parts destroyed by improper assembly or handling.
Our products, part of which are pre-assembled, are not fully assembled and checked for function before shipping
but are merely assembled to facilitate assembly. Loading, unloading and transport cause shocks to which the prod-
uct is not exposed when in "normal operation", therefore it is imperative to check for loosened screw connections.
Basically, the following applies: pre-assembled parts must be checked, retightened, greased and oiled and, if nec-
essary, repaired in accordance with the recognised rules of technology before commissioning. This also applies to
components that still must be mounted on the contraption. It may also happen that e.g. a thread soiled by paint will
have to be cleaned: this is considered a normal aspect of the assembly of a rack and not a defect in the sense of
the warranty. Nor to be considered a defect, is a screw that has been strangled/wrought by screwing it in crookedly
or torn off by excessive torque: these risks are borne by the fitter/mounter.
Check
screws and mechanics
for correct and tight fit, check moving parts for free movement and lubricate.
3.2
Choice of location
The rack is approved for assembly in closed dry workshop rooms. Use in damp and wet rooms as well as in rooms
at risk of explosion is not permitted. The rack unit must be set up and stored on a level surface!
3.3
Functional description
The rack is used for safe transport and storage of mowing robots in workshops and sales rooms.
3.4
Preparation for mounting
Ensure that the unit is clean, and that sufficient working space is available for installation. Open the packaging and
remove the parts. Ensure that no parts are lost.
Sort the screws according to the following sizes!
16x M8 : black for rollers
16x washers for M8 (rollers)
16x nut M8 for rollers
4x M6 x for handle
2x M8 x 75
8x M8 x 70
6x M8 x 65
8x M8 x 55
24x cap nut M8
