O
perating Instructions for Hand Pallet Truck
76072170
7
e) The drawbar is now connected to the pump.
Figure 2
Figure 3
4.2
Adjusting the switching device
In the upper part of the drawbar of this pallet truck is the operating lever (117 or 120G),
which can have three positions:
Lifting position of the fork -
lower handle
Drive position
-
handle in middle position
Lowering the fork
-
handle on top
NOTE: If the settings have been altered for any reason, they can be adjusted as
follows:
a)
If the forks lift in the lever position “DRIVE” during pumping movements, turn the
adjusting nut (104) on the adjusting bolt (103) or screw (318) clockwise until the forks
do not lift during pumping movements and the driving position works without problems.
b)
If the forks lower in the lever position “DRIVE" during pumping movements, turn the nut
(104) or bolt (318) counter-clockwise until the forks stop lowering.
c)
If the forks do not lower when the control lever (117 or 120G) is
in the “LOWER” position,
turn the nut (104) or screw (318) clockwise until the control lever (117 or 120G) is
operated. Then check the “DRIVE” function as described in 3.1 and 3.2 to ensure that the
nut (104) and the screw (318) are in the correct position.
d)
If the forks do not lift in lever position “RAISE”, turn the nut (104) or screw (318) anti-
clockwise until the forks lift in lever position “RAISE” during pumping movements. Then
check the lever positions “LOWER” and “DRIVE” as described in 3.1, 3.2 and 3.3.
