Compressor Operating Instructions
61099049
6
The suction of flammable gases etc. can lead to deflagration and explosions. This can
result in severe to fatal injuries and extensive damage to property.
3.3.
Main components
Figure 1
The compressor is supplied with a pre-set pressure valve control. The operating and switch-
on pressure can be controlled via the setting options.
The maximum permissible pressures and flow rates must not be exceeded under any
circumstances.
If the permissible operating pressures and flow rates are exceeded, this can lead to
serious accidents and damage to property.
3.4.
Getting the machine ready for operation
To disconnect the compressor from the mains completely, the unit must be switched off using
the switch (Fig. 2) and then disconnected from the mains by pulling the mains plug.
The compressor can only be prepared for operation by people with sufficient technical
expertise. All other operators must have the installation commissioned by a specialist.
For the first commissioning, first remove the motor cover (Fig. 1 no. 12), then connect the
drain pipe (Fig. 4 no. 26) and the drain valve (Fig. 4 no. 24). Afterwards the air filter (Fig. 4
no. 47) must be inserted into the designated holder.
Never loosen parts of the compressor while there is still compressed air in the container.
Sudden pressure release can lead to operating conditions that are difficult to control
and can cause serious injuries.
1.
Main compressor
2.
Pressure valve control
3.
Release valve 1
4.
Regulator valve
5.
Pressure gauge
6.
1-way valve
7.
Drain valve
8.
Wheel
9.
Vent pipe
10.
Compressed air tank
11.
Safety valve
12.
Motor cover
1
2
3
4
5
6
7
8
9
10
11
12
