STEP 5
Fix the other Rafters (
3
) to complete
the square.
STEP 6
Check the assembly is upright, level
and square. Once this has been
acheived concrete the posts in place.
ALLOW THE CONCRETE TO SET
SOLIDLY BEFORE CONTINUING.
STEP 7
Take two of the Curved Beams (
5
).
Lay them on a solid flat surface with
the two flats at the profiled end
pushed together
(as fig.4)
.
Using one of the Nail Plates (
t
)
fasten the two together.
Carefully turn them over and fit
another nail plate to this side.
STEP 8
Repeat Step 7 for the remaining
three pairs of curved beams.
STEP 9
Determine the position of the two
intermediate curved beams along
Rafters (
2
)
(as fig.5)
.
Mark the positions.
STEP 10
Take the Apex Rafter (
4
) and mark
the position for the curved beams.
Measure from the centre.
STEP 11
Position one of the curved beam
assemblies across one of the Rafters
(
3
)
(as fig.6)
.
STEP 12
Locate the Apex Rafter (
4
) into the
cutout at the top of the curved beam
assembly.
STEP 13
Position one of the curved beam
assemblies at the opposing end of
the Apex Rafter (
4
) lifting it into
position on the other Rafter (
3
).
STEP 14
Position the two remaining curved
beam assemblies. Lift them into
place in the upside down position
and rest them on the rafters. Rotate
each one into position at the marked
places.
STEP 15
Check all of the beams are
positioned correctly. Using screws
(
v
) fix each of the curved beam
assemblies to the apex rafter on
both sides
(as fig.7)
.
=
863mm
864mm
432mm
432mm
863mm
=
5
5
4
5
4
v
v
5
5
2
3
1
t
t
t
x
x
x
x
x
1295mm
1295mm
x
x
x
fig.4
fig.5
fig.6
fig.7
