5
Figure 19
6
RS2 32
Figure 21
Figure 20
Power cord
Manual Control Switch
Projector
Central controller
Computer Output Jack
Connecting External IR
Trigger Jack
Remote Control Instruction
Functions
Press down and open the end cap lid to access the control interface. When not in use, close to the lid to
conceal the control interface.
Operating Instructions
Other Control Options (optional)
1.Convert the infrared control to a FM wireless control using the Wireless Synchro Converter Receiver.
2.Control using the Intelligent Synchro Power Supply Control Adaptor for inline control with the projector. Please
refer to specific manual instructions if options A and B are paired.
Connecting to an external power source:
1.Remove the glued on cloth on the bottom rod to ensure the rod is free from the casing.
2.Switch on the power. (with the appropriate voltage)
How to use the Manual/Remote Control Switch Button (Figure 20-21)
This motorized screen has 4 types on control options: infrared (IR) remote control, manual control, triggered control,
and external control (central control or RS232/USB).
Switch control follows this priority: Down-Stop-Up-Stop-Down
End cap lid
Button Function and Operation Instruction :
1.Press UP button to lift the screen
2.Press STOP button to stop the screen
3.Press DOWN button to lower the screen
4.Press MICRO-UP button to retract the screen in small
increments(150ms for each movement)
5.Press MICRO-DOWN button to lower the screen in small
increments (150ms for each movement)
Cautions:
1.The minimum distance between Controller and Receiver: 50cm
2.Workable within 8m in horizontal directionfrom the Receiver to the
Controller
3.Do not cover the Controller’s launching port while operation
4.Strictly banoperation in wet or high temperature environment.
5.Replacing batteries when the signal is faint or no signal.
6.Batteries for the Controller: 2 units CR2032 button cells.
Batteries Installation Instruction:
When the signal of the Controller is faint, please replace the batteries
as follow steps:
1.Reverse Controller to the back, push down as the arrow mark to open
the cover.
2.Installtwo cells of battery and set the direction of positive and
negative electrode just like the chart shows.
3.Close the battery cover.
LED
UP
STOP
DOWN
Micro-up
Micro-down
Model:AC127
Push down
