1GD-868Mn
Ⅲ
Set up for controller's batteries
Model of the batteries: AAA1.5x2
1. Counter turn the remote controller and open the
battery cover according to the drection of arrow
2. Fix in the batteries according to the figure on the
left side.
3. Close the battery cover.
Please change the batteries according to the following steps when the signal of remote
cotrol becomes weak.
Features of the Receiver
Technical features of the receiver: Reliable, Energy Conservated and Environmentall Friendlly
> Using STM paster with damproof processing
> Automatically shut off power if there are no operation in one minute
> Using a certified connector to ensure the safety
> One receiver can receive maximum 20 sets of codes from eimitter which means user could
control the receiver with maximum 20 pieces of emitter
> One receiver can be only connected to one pieces of electric screen
Model: 1 GD-868Mn Receiver
Ⅲ
ISPR
Signal programming
Indicator light
CAUTION
Warning: Please do not expose the product in moist place to prevent from potential danger
of fire or electric shock
1. Please read this instruction carefully before using to prevent from potential damage to the
product cause by inappropriate operation
2. Please put the product in ventilated place and operate according to instruction
3. Please move away from heat source such as heating machine, stove and other equipment
that generate heat
4. Please only connect to the power source with earth wire
5. Never step on or clamp the power line
6. Please only use the accessories provided by supplier
7. Please unplug the power line during thunderstorm or long time lay aside
8. Please handover the maintanence work to professional after-sales staff
9. Please keep the product away from water and do not put anything with water on the product
such as vase
10. As long as the power line is connected to the power source, the product is still connected to
the alternating current power supply
Parameters of the receiver:
> Power source: AC230V/50Hz, 120V/60Hz The actual figure should refer to the parameter
sticker on the box
> Working Temprature: -20
℃
to +80
℃
> Maximum Load: 600W
> Operating Frequency: 868MHz
Match with Integrated Synchro Power Relay( hereafter be shorted as ISPR; optional)
After simply learning and matching the ISPR with the projector, screen may be controlled to lower
or retract as the projector is on or off.
1. Plug in the ISPR and the receiver
2. Press SW5 learning button on the receiver, the indicator light starts flashing repeatly, then the
learning begins ( learning status will stop automatically after 15 seconds)
3. Press learning button on the ISPR emitter, then the indicator light shines
4. Learning indicator light of the receiver flashes twice rapidly, learning succeeds.
Method:
Note: For more instruction details, please refer to the user manual for ISPR.
The receiver is the controller between power source and the
electric screen, to control the fabric to go up, down or stop.
The receiver can control the screen with three methods
mentioned below:
1. Using the RF emitter to control the fabric to go up, down or
stop. The receiver could only work with the 1GD-868Mn
emitter that provided by our company and the effective
working radius is 50 meters.
2. Using the button on the box to control the fabric to go up,
down or stop.
3. Can be connected to an external dry contact switch to
control the fabric to go up, down or stop
