602A
L08C-X
S04
ML01
W05 CLIP
L08C
4.9
Before you attach the 602A’s to the sides
of the greenhouse you will need to loosen the
ML01 (nut) attached to the L08C-X and L08C
located at the base. Once the bottom of
L08C-X’s are loosened on one side attach the
602A’s to the sides of the greenhouse in this
order.
1. Hold the 602A in place as shown and attach
the top of the 602A to the 609 using
S04/ML01 (nut and bolt). As shown in .
2. Now attach the bottom of 602A to the L08C
and base using a S04/ML01 (nut and bolt) and
W05 (base clip) as shown in .
Note: Where the L08C-X reattaches to the
L08C and the 602A be sure to secure them
with a W05 (base clip) to the base see .
3. Repeat for the other side.
4.10
Install plastic strip 606 before inserting
polycarbonate sheet Y7’s, see .
4.11
After Y7’s are installed on both sides,
loosen bolts attached to L08C-X in all upper
corners. Using a level, adjust 602A and tighten
bolts. Repeat in every corner until the
greenhouse is level. The top edges of Y7’s will
align when greenhouse is level.
Inside View
609
602A
Inside View
24
STEP F
OUR
601B
L08C-X
602A
L08C-X
L08C
609
W05
Base
602A
Inside View
L08C
Polycarbonate Panel
606
L08C
Outside
