I
N
S
P
E
C
T
I
O
N
12
12
Product shipping can reposition the rotisserie burner spark electrode.
If your barbecue and side burner are completely assembled and
this rotisserie burner electrode does not continuously spark, then
conduct this adjustment.
1.
Turn the gas supply off at the gas cylinder.
2.
Be sure the AA battery is installed and ensure the connections
are secure.
3.
Push the ignition button and watch for a small blue spark at
the rotisserie burner electrode tip. If there is no spark you
must adjust the gap between the electrode tip and the
stainless steel rotisserie burner screen. The gap should be
adjusted to approximately 5 mm or closer.
4.
Adjust the gap using needle nose pliers. DO NOT adjust the
gap by hand or touch the white ceramic electrode insulator.
Using one set of needle nose pliers, securely hold the electrode
as shown above. With another set of pliers, gently bend
the tip end of electrode to within 5 mm of the stainless
steel screen. Be careful not to puncture the screen or break
electrode tip.
5.
Try spark electrode test again. Re-adjust if necessary.
BACK BURNER SPARK ELECTRODE TEST
AND ADJUSTMENT
Do not touch the
white ceramic
electrode insulator
1.
With burner controls in
‘OFF’
position, open the gas cylinder
valve or connect to gas supply.
2.
Upon first assembly the gas lines and burners will be full of
air. In order for the burners to light properly the lines must
fill with gas. It may require several attempts at lighting the
burners before you are successful.
3.
Push the igniter button and check for sparking at the
stainless steel gas collector, located adjacent to each burner.
4.
If a spark is not evident at the gas collector, check that the
ignition lead is firmly attached to the spark plug.
5.
With sparking established at collector box, turn the burner
control to
‘HI’
to establish a flame on the burner.
6.
Push and turn the required burner control as required in an
anti-clockwise direction to the
‘HI’
position. Cross lighting
channels inside the barbecue body enables the flame to
transfer across to the centre and opposite side burners to
ignite them.
7.
If any burners fail to light after several attempts, turn off gas
supply at source.
Wait until burners cool and inspect for obstructions to gas flow.
See also Safety instructions (pages 3, 4), Lighting and Operating
instructions (pages 14, 15)
.
BURNER OPERATION
AND IGNITION SYSTEM CHECK
Piezo igniter
5 mm
Gas valve assembly
Orifice
Burner tube
Gas collector /
electrode
AA
battery
Spring
Igniter
cap
Contact
IGNITION BATTERY
