Grand Design Solitude 2017, Руководство пользователя

Страница: 85 / 204

83
5. When the leveling legs are in the desired position,
close valves
B
and
C
by inserting a 5/32” Allen wrench
into the manual override and rotating it 1.5 to 2 turns
counter-clockwise until snug. DO NOT over-tighten .
6. Open valve A by inserting a 5/32” Allen wrench into the
manual override and rotating it 1.5 to 2 turns clockwise .
7. Extend or retract the landing legs to the desired
position using the “Slide Room 1” button, located
in the Command Center.
Close valve A by inserting a 5/32" Allen wrench into
the manual override and rotating it 1.5 to 2 turns
counter-clockwise
until snug. DO NOT
over-tighten
.
Option 2 – in the event the pump is in operable
1. Make sure valve
D
is open. To open valve
D
, insert a
5/32” Allen wrench into the manual override and rotate
it 1.5 to 2 turns clockwise .
2. Open valves
B
and
C
by inserting a 5/32” Allen wrench
into the manual override and rotating it 1.5 to 2 turns
clockwise .
3. Peel off the protective seal G, located on the end of
the motor that is attached to the hydraulic reservoir.
4. Attach a 1/4” hex head bit to your hand drill
(customer supplied), and insert it into Coupler
G
(previously hidden under the protective seal).
Run the drill clockwise to extend the level-up jacks
and counter-clockwise to retract them.
When the leveling legs are in the desired position,
close valves
B
and
C
by inserting a 5/32” Allen wrench
into the manual override and rotating it 1.5 to 2 turns
counter-clockwise until snug. DO NOT over-tighten .
5. Open valve A by inserting a 5/32” Allen wrench into the
manual override and rotating it 1.5 to 2 turns clockwise .
6. Extend or retract the landing legs to the desired position
using coupler
G
.
Close valve
A
by inserting a 5/32" Allen wrench into
the manual override and rotating it 1.5 to 2 turns
counter-clockwise until snug. DO NOT over-tighten .
D.
C. B.
A.
G.
F. E.
Towing & Leveling