9
GrandCanyonGasLogs.com
INSTALLATION
Coil the wire using proper aluminum tube bending
techniques and insert the pilot tube flare connection
into the left side of the valve. Finally locate the “S” & “I”
wires connected to the pilot assembly and insert them
into the green control module.
Locate the valve/ control module to the left side of the
burner. Then connect the 10" x ½" whistle free flex line
to the gas outlet of the valve and the gas inlet of the
burner. Using proper wrench, tighten the connections.
Using the long valve heat shield, cover the valve and
control module. This is a tight fit and ensure that
none of the connections get pinched.
Run the extra length of the wiring harness behind the
burner. Then locate the battery pack/receiver on the
right-hand side of the burner. Cover the Battery pack/
receiver with the battery pack heat shield.
