19
Install Ignitor Battery
Unscrew Ignitor Cap from Range and Grill
Control Panels.
Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Install Cooking Components
Place the Savor Plates
®
above the
Burners.
Place the Cooking Grids on the ledge
above the Savor Plates
®
.
Place the Secondary Cooking Rack into
the holes on the upper left and right of
the Back Burner frame with the bottom
resting in the slots on either side of the
Grill Bowl.
Secondary Cooking Rack
Savor Plates
®
10
Cooking Grids
7
•
•
•
Using an adjustable wrench, loosen the
Inside Nut until the Gas Collector Box can
be turned upward.
If the gap between the Spark Elec-
trode Tip and Receiver is more than
3/16" use long nose pliers to gently
squeeze the Gas Collector Box to
narrow gap.
Return the Gas Collector Box to its
original position, secure the Inside Nut
and try the Electrode Check again. If no
"clicking" sound is heard:
AA Battery may be installed back-
wards.
Electric wires may be loose. Remove
the AA Battery and inspect the Ignitor
Junction Box found behind the Control
Panel and reconnect any loose wires.
Side Burner Electrode Check
-
Open range lid. Remove packing mate-
rial (cardboard and styrofoam) from
burner and pot support.
Push and turn side burner Control Knob
to HIGH/IGN. Look for spark between tip
of electrode and burner.
If you don't see a spark from side burner elec-
trode, adjust gap between electrode and
burner surface to 3/16 in.
9
-
Be sure all Control Knobs are set to
"OFF" and open the Grill Lid.
Have your assistant stand behind to the
right of the grill and look toward the front
of the grill bowl.
Never
put your face
inside the Grill Head.
Press the Ignitor Cap. You should hear
a "clicking" sound. Your assistant should
see a blue spark within each Gas
Collector Box. If a spark is present the
Electrode Tips are properly positioned.
If no spark is seen, the Spark Gap
needs to be adjusted as follows:
With the assistance of another person,
perform this Electrode Check before
proceeding
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
Spark Electrode Tip
Spark Receiver
Spark Gap
Gas Collector Box
8
8
Spring
Ignitor Cap
Ignitor Slot
AA Battery
AA Battery
Ignitor Slot
Spring
Ignitor Cap
Range Control Panel
Grill Control Panel
