1147-INS-LAB-RevD19
10
SETUP
BATTERY INSTALLATION
1. Remove the battery cover and insert batteries into the battery
compartment with polarities “+” and “-” matching polarity indicator.
Replace the battery cover.
2. Use only fully-charged AAA alkaline batteries.
3. Always replace all three batteries at the same time.
4. The built-in clock may need to be reset and reading memories may
be erased after battery replacement.
5. Dispose of used batteries in compliance with local regulations for
environmental protection.
SETTING THE CLOCK
1. To have correct date and time for memory storage, the built-in clock
needs to be set before beginning first measurement.
2. Under power-off mode, press and hold the MEMORY button until
the display shows a blinking year, then press the POWER button for
adjustment. After current year is selected, press the MEMORY button
to set it and switch to next adjustment.
3. Repeat previous steps to adjust and set current month, day, hour,
and minute one by one while they are blinking.
4. AFTER setting the clock, proceed to step 5 to finish setting the clock,
or press the MEMORY button if you wish to set the ALARM feature.
a. Press the POWER button until the desired time is shown.
b. Press the MEMORY button to save desired time for AL1 (user 1).
c. Proceed to step 5 to finish setting the clock, or press the
MEMORY button to set the ALARM feature for the next user; you
may continue in this manner to set the ALARM for users 2, 3 and
4 (AL2, AL3, and AL4).
5. Press the MEMORY button again to finish setting the clock.
