IV-O2 Holder Installation Instructions
B10320E-
I
Revision B
Graham-Field Health Products, June 2005
2
Assemble IV-O2 holder
1. Install intermediate tube (middle section) on O2 holder (lower section) as shown in picture at lower left:
Slide middle pole over lower pole until button lock pops out of the hole in middle pole.
Ensure that
button lock protrudes fully from hole.
2. Install IV hanger (upper section) in intermediate tube (middle section) as shown in picture at lower left:
Slide upper pole into middle pole to desired height and position until the height-adjustment button lock
pops out of the appropriate hole in middle pole.
Ensure that button lock protrudes fully from hole.
Adjust IV hanger height
1. Depress height-adjustment button lock until IV hanger slides freely inside intermediate tube.
2. Slide IV hanger inside intermediate tube to desired height and position until the height adjustment
button pops out of the appropriate hole in intermediate tube.
Ensure that button lock protrudes fully
from hole.
WARNING: Do not use IV-O2 Holder unless assembled as
described. Ensure that all components are se-
curely installed before use, and that all button
locks protrude fully through holes.
Note: After installing O2 bottle in O2 holder, tighten thumb screw shown
in picture at left until O2 bottle is secure and does not rattle in O2
holder.
Maintenance
Check IV-O2 holder at least once a week to ensure that it is not bent
or damaged, and that all parts lock securely in place and will not
accidentally unlock. Wipe IV-O2 holder with a soft cloth
and dry immediately if exposed to moisture. If
necessary, wash with a mild soap and water
solution and rinse; never use abrasive
cleansers on IV-O2 holder.
