6
EN
water (without coffee grounds) to thoroughly flush the system. Proceed as described in the „Prepa-
ring espresso“ section.
Unpacking
To unpack the unit, proceed as below:
•
Take the unit out of the carton.
•
Remove all pieces of the packing.
•
Remove any possibly extant labels on the unit. (not the rating plate).
Requirements for the installation location
For safe and flawless operation of the unit, the place of location must meet these prerequisites:
•
The unit must be set up on a firm, flat, level, non-slip and heat resistant base that has sufficient load
bearing capacity.
•
Select the place of location so that children cannot reach the hot surfaces of the unit.
•
The unit is not intended for installation in a wall or a built-in cupboard.
•
Do not set up the unit in a hot, wet or moist environment.
•
The electric socket must be readily accessible so that the power cord can be easily unplugged.
Using the control panel
POWER
Press the „POWER“ button once to turn the unit on.
The light behind the „POWER“ button will illuminate red and start flashing, this is to indicate that
your unit is on and heating up.
If the light turns to a constant green light, this indicates that the unit is heated and ready for use.
Before activating the espresso coffee function ensure that the steam and hot water control dial is in