Grady-White Boats Canyon 336, Руководство пользователя

Страница: 76 / 126

3 3 6 C
A N Y O N
8–12
DC P
OWERED
A
CCESSORIES
• Cabin Lights
The cabin light switch supplies power to the light in the cabin. However, the dome light also
has a switch on the bezel of the light fixture.
• Cockpit Shower
To operate the cockpit shower located near the transom door and on the lean bar, the water
pressure switch located on the DC panel must be in the “on” position. Pull out the hose and
depress the button on the back of the wand to spray water. To reinstall the shower, simply feed
the hose back in the outlet and allow the faucet to rest in the storage cup. If your boat is
equipped with the cockpit shower hot water option, you will have a mixer knob installed to
adjust the water temperature. To supply the optional hot water to the cockpit shower, make
sure the hot water heater is on
(reference “DC Powered Accessories” on page 8–12) , then
adjust the mixer knob located at the cockpit shower.
• Cockpit Switch Panel
This panel is located at the helm and is used to operate those systems which are not included
on the AC/DC panel. The switches are backlit for low light situations and have individual
breakers located above them. Refer to
“Switch Panel” on page 8–2 for information regarding
the operation of switches included on this panel.
• Freshwater Washdown
To operate the freshwater washdown, depress the water pressure switch on the accessory
switch panel. This system will now be pressurized at the “freshwater” washdown outlet. A
hose with a spray nozzle attached may be used intermittently without turning the switch off in
the same fashion as a home garden hose with a nozzle. The freshwater pump has an internal
pressurization switch that will maintain water pressure as needed until the switch is turned off
at the switch panel.
• Head Shower
To use the head shower, the “WATER PRESSURE” switch located on the DC panel must be
activated. This provides pressure to the hot and cold water supplies. Water flow is controlled
by the head shower fixture and a conservation valve built into the pull out wand.
• Livewell - Raw Water
To operate either the starboard or optional port livewell, open the corresponding seacock with
the livewell I.D. tag located in the aft bilge. The remote arm for these seacocks may be
accessed through the aft rigging door beneath the folding aft seat. The livewell pump is
screwed directly into this seacock. The livewell switch at the helm should be in the on
position. Place the livewell standpipe in the drain located at the bottom of the livewell. Screw
it down until the black flange makes contact with the flange on the drain fitting. Water will
enter through a plenum along the side of the livewell and be distributed through a series of
holes arranged vertically along the plenum. The water will rise to a depth even with the
strainer on the standpipe and drain overboard. To evacuate debris and bait waste from the