Grady-White Boats Canyon 336, Руководство пользователя

Страница: 68 / 126

3 3 6 C
A N Y O N
8–4
M
AIN
C
IRCUIT
B
REAKER
There is a 50 amp circuit breaker located in the panel beneath the battery select switches. This
is the main breaker protecting the wiring supplying power to the accessory switch panel. This
breaker may be manually tripped by moving the arm to the “off” position. If this breaker is
tripped, moving the arm back to the “on” position will reset it.
A
CCESSORY
O
UTLET
- 12 V
OLT
Two 12-volt outlets are installed on your 336. One is on the starboard side of the helm facing
outboard and the other is on the aft side of the helm. These outlets provide easily accessible power
supplies for accessories such as cellular phones and spotlights.
B
ATTERY
S
ELECT
S
WITCH
The Canyon 336 is equipped with four batteries and two battery select switches. The batteries
are grouped into two banks, each bank consisting of two batteries wired in parallel. One battery
select switch is designated for each engine, and the accessories operate from the same switch as
the starboard engine. See
“Battery Wiring With Select Switches” on page 8–37 for a battery
wiring diagram.
An outboard engine should be connected to each battery select switch. Either engine may be
started with either battery bank by selecting position “1” or position “2” on the select switches. In
normal use, select position “1” on the starboard switch and position “2” on the port switch so that
both battery banks will charge simultaneously with the engines running.
B
ILGE
P
UMP
W
ITH
F
LOAT
S
WITCH
Your boat is equipped with automatic float switches adjacent to the bilge pumps. A float
switch will enable the pumps to come on automatically if a significant amount of water
accumulates in the bilge. The float switches function independently of the battery select switches
and can activate the bilge pump with the battery select switches in the “off” position. The bilge
pumps are also equipped with switches at the helm. When a switch is in the “on” position the
pump will run continuously. The pump should not be left in the on mode unless someone is
monitoring the system and can turn the pump off when the bilge is dry. When a switch is in the
“off” position, the pump is off unless activated by the float switch.
N O T I C E
These outlets cannot be used with a cigarette lighter.
W A R N I N G
Never turn the battery select switch to the “off” position with an engine (including generators)
running as this could damage the engine charging system or the generator control panel.
C A U T I O N
To prevent damage to the bilge pump, do not run it dry for a prolonged period of time.
!
!