Graco ThermoLazer, Операция

Страница: 21 / 40

Lighting Instructions
3A1319K 21
Shutting Off Torch
1. Fully close torch flame adjusting valve.
2. Close manual shut-off valve on propane tank when
finished melting and heating thermoplastic material.
Front Screed Box Burner
Lighting Instructions
Read Important Safety Information , page 14-16.
1. Make sure screed box burners flame adjusting valve
is turned OFF.
2. Open manual shut-off valve on propane tank
located at front of unit.
3. Light torch (see Torch Lighting Instructions, page
20).
4. Open screed box access door.
5. Slowly open screed box burners flame adjusting
valve.
6. Place torch at end of screed box burners to ignite
and use screed box burners flame adjusting valve to
adjust to desired flame.
7. Visually inspect to make sure flame indicators are
glowing.
Shutting Off Burners
1. Fully close screed box burners flame adjusting
valve.
2. Close manual shut-off valve on propane tank.
ti14605a
ti14128a
ti14140a
ThermoLazer 300
TC
shown
NOTICE
If material begins to smoke or become discolored, turn
screed box burners down or off to prevent material
from burning.
ti23072a
ThermoLazer 200/200
TC
ThermoLazer 300
TC
/ProMelt
ti14142a