Graco ThermoLazer, Операция

Страница: 16 / 40

Important Safety Information
16 3A1319K
Important Safety
Information
Before attempting to start equipment:
DAILY: Check all gas lines and fittings for gas leaks.
DAILY: Check gas supply hose for wear, abrasions,
cuts or leaks. Replace only with hoses recommended by
Graco.
Check gas supply hose connection to LP-gas cylinder.
Make sure fitting is free of debris before connecting to
tank. Make sure gas connection is screwed completely
on and is free of leaks.
Check to ensure that the following are closed:
• LP Gas Tank manual shut-off valve
• ControlFlow gate valve
• Front screed box burner flame adjusting valve
• Torch/flame adjusting valve
• Screed box burner flame adjusting valve
(24H622 and 24H624 only)
• Kettle gas burner manual shut-off valve
• Kettle gas safety valve
• Kettle temperature control knob (turn to “OFF”)
Check to make sure exhaust openings on kettle are not
obstructed.
Check to make sure combustion air supply openings on
kettle are not obstructed.
If you do not follow these instructions exactly, a fire
or explosion may result causing property damage,
personal injury or death.
All surfaces are capable of becoming extremely hot.
Be sure to always wear heat-resistant gloves and
other protective equipment rated for 500° F (260°
C). Material and unit are very hot 350° - 500° F
(177° C - 260° C). Never exceed material maximum
temperature rating.
Hot molten plastic will burn skin. Do not attempt to
remove from skin. Cool under running water and
seek medical attention.
See MSDS for Thermoplastic Traffic Marking
Compound.
FIRE AND EXPLOSION HAZARD
If using this unit in conjunction with LineDriver
®
, do
not fill gasoline tank while burners are ignited. Allow
equipment to completely cool before refueling.
INHALATION HAZARD
Melting thermoplastic produces toxic fumes. Avoid
prolonged inhalation of fumes.
ti14412a
ti16838a
ThermoLazer 300
TC
shown
ThermoLazer ProMelt shown
Exhaust
Openings
Air Openings
ti25699a
Air
Openings