Graco Therm-O-Flow 243698, Инструкция по эксплуатации

Страница: 8 / 24

Installation
8 309213G
Installation
Connecting the Electrical
Control Panel to a Power Source
F
IG
. 3
Have a trained electrician connect the electrical control
panel (Fig. 3) to a grounded electrical source that has
the required service ratings:
To connect the control panel to the electrical source:
1. Locate the opening in the control panel’s bottom
housing for the conduit that will enclose the wire
from the facility’s power source. The hole diameter
is .804” (20 mm) and includes a cord strain relief for
cable diameters from .236” (6 mm) to .472” (12
mm).
2. Thread the wire from the power source into the con-
trol panel housing , and then connect the power
source wires to the appropriate terminals on the
panel . See Electrical Schematics beginning on
page page 19 .
WARNING
ELECTRIC SHOCK HAZARD
Do not connect the electrical control panel to
a power source unless you are a trained
professional. Failure to follow standard
procedures or to observe the necessary
precautions could result in serious bodily
injury or equipment damage.
CAUTION
If power and grounding connections are not done
properly, the equipment will be damaged and the
warranty will be voided. Check the label on the
control box for the proper voltage.
AC
Panel Voltage Hz Phase Full Load Amps
220/240 50/60 1 15.5A - 4-Zone
Control (243699)
11.0A - 2-Zone
Control (243698)