![background image](http://html1.mh-extra.com/html/graco/therm-o-flow-243698/therm-o-flow-243698_instructions-manual_2251035003.webp)
Warnings
309213G
3
Warnings
The following are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point
symbol alerts you to a general warning and the hazard symbol refers to a procedure-specific risk. Refer back to these
warnings. Additional product-specific warnings may be found throughout the body of this manual where applicable.l
WARNING
BURN HAZARD
Equipment surfaces and fluid that's heated can become very hot during operation. To avoid severe burns,
do not touch hot fluid or equipment. Wait until equipment/fluid has cooled completely.
SPLATTER HAZARD
During blow off of platen splatter may occur.
•
Use minimum drum removal air pressure.
MOVING PARTS HAZARD
Moving parts can pinch or amputate fingers and other body parts.
•
Keep clear of moving parts.
•
Do not operate equipment with protective guards or covers removed.
•
Pressurized equipment can start without warning. Before checking, moving, or servicing equipment,
follow the
Pressure Relief Procedure
in this manual. Disconnect power or air supply.
ELECTRIC SHOCK HAZARD
Improper grounding, setup, or usage of the system can cause electric shock.
•
Turn off and disconnect power at main switch before disconnecting any cables and before servicing
equipment.
•
Connect only to a grounded power source.
•
All electrical wiring must be done by a qualified electrician and comply with all local codes and regula-
tions.
TOXIC FLUID OR FUMES HAZARD
Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on the skin, inhaled, or
swallowed.
•
Read MSDS's to know the specific hazards of the fluid you are using.
•
Store hazardous fluid in approved containers, and dispose of it according to applicable guide- lines.
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
•
Do not exceed the maximum working pressure or temperature rating of the lowest rated system com-
ponent. See
in all equipment manuals.
•
Use fluids and solvents that are compatible with equipment wetted parts. See
in all
equipment manuals. Read fluid and solvent manufacturer's warnings. For complete information about
your material, request MSDS from distributor or dealer.
•
Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
Graco replacement parts only.
•
Do not alter or modify equipment.
•
For Use equipment only for its intended purpose. Call your Graco distributor for information.
•
Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
•
Do not kink or over bend hoses or use hoses to pull equipment.
•
Keep children and animals away from work area.
•
Do not operate when fatigued or under the influence of drugs or alcohol.
•
Comply with all applicable safety regulations.
Содержание Therm-O-Flow 243698
Страница 19: ...Electrical Schematics 309213G 19 Electrical Schematics 230 240 VAC 2 Zone...
Страница 20: ...Electrical Schematics 20 309213G Electrical Schematics 230 240 4 Zone...
Страница 21: ...Electrical Schematics 309213G 21 Electrical Schematics 230 240 4 Zone continued...
Страница 22: ...Dimensions 22 309213G Dimensions Electrical Control Panel Mounting and Clearance Dimensions FIG 7...