Operation
3A6746B
7
Operation
Adjust Spray Pattern
NOTE:
See T-Max Operation Manual for more details.
1. Remove spray disk and adaptor and rings so only
the nozzle is left on the front of the gun.
2. Turn applicator ON and adjust sprayer to determine
fluid flow and pressure. A good starting point is to
adjust fluid flow until you have an 9 in. (20 cm)
stream.
3. Clean off any material that oozed out of the air holes
in the round nozzle.
4. Attach spray disk, adapter, and hand-tighten rings.
Hold gun 18 to 30 in. (0.5 to 0.8 m) from a test
surface and turn on air needle valve to allow air to
atomize fluid. Test spray pattern.
5. Adjust air needle valve to achieve desired spray
pattern.
NOTE:
More fluid flow = more air; Less fluid
flow = less air.
6. If the desired spray pattern cannot be achieved, try
adjusting air pressure or try another spray disk and
nozzle combination.
7. When done spraying, release trigger. The fluid
passage will stay open, relieving pressure. Pressure
is relieved when fluid stops flowing.
8. When pressure is relieved, press trigger stop button
to close fluid passage.
Cleanup
Thoroughly flush STX spray trigger gun after each work
session before fluid begins to cure in gun. Store in a dry
location. Do not leave the applicator or any parts in water or
cleaning solvents.
