Calibration
Calibration
Calibration Checks
Checks
Checks
Pump
Pump
Pump Pressure
Pressure
Pressure Check
Check
Check
NOTE:
NOTE:
NOTE: Enter the transducer calibration data before
doing the pressure check.
Perform
Perform
Perform the
the
the pressure
pressure
pressure check:
check:
check:
• The first time the system is operated.
• Whenever new materials are used in the system,
especially if the materials have viscosities that
differ significantly.
• At least once per month as part of regular
maintenance.
• Whenever a pump is serviced or replaced.
During each pressure test, the dose valve will close
during an up stroke and a down stroke (in either
order). This test is to verify that the valves are
seating properly and not leaking. If leaking occurs,
the system will alarm after the test for that particular
pump direction.
NOTE:
NOTE:
NOTE: Do not trigger the spray device during the
pressure check.
1.
The pump and lines must be primed with a
component (not solvent) before doing the
Pressure Check. See
.
2.
If the display is on a Run Mode screen, press
to access setup screens.
3.
Scroll to Calibrate to display
4.
Press the Pressure Check
button for the
desired pump. The pump will build pressure in
the line to a minimum of the Stall Test Pressure.
The pump will then move to the center stroke
position and stall test the upstroke, followed by
the downstroke.
5.
The pressure and flow that the unit measured
are displayed on the screen. Compare
with the maximum leak rate entered on
. If the values are
substantially different, repeat the test.
NOTE:
NOTE:
NOTE: The stall test pressure set point is a
minimum. The system may stall at a higher
pressure depending on hose lengths and fluid
composition.
94
3A6287E
