Graco ProMix PD3K Plus, Операция

Страница: 87 / 122

Setup Mode Screens
Calibration Calibration
Calibration Screens
Screens
Screens
Calibrate Calibrate Calibrate Screen Screen Screen 1 1 1
Calibrate Screen 1 initiates a pump pressure check
(stall test) for the selected pump. During the test, the
Stall Test screen will appear.
The pump and lines must be primed with a
component (not solvent) before doing the stall
test. See
System Screen 2, page 68 , to set test
parameters. See Pump Pressure Check, page 94 ,
for complete test instructions.
To initiate the test, press the Pressure Check
button for the desired pump. The system will first
check the inlet pressure due to the material supply
pressure. If this pressure is greater than 90% of
the Stall Test Pressure, the system will generate an
alarm and halt the stall test. The pump will build
pressure in the line to a minimum of the Stall Test
Pressure. The pump will then move to the center
stroke position and stall test the upstroke, followed
by the downstroke.
NOTE: NOTE: NOTE: The Last Passed log can only be reset by
successfully completing the test.
The screen displays the number of days since the
last stall test was passed for each pump.
Figure 70 Calibrate Screen 1
Figure 71 Stall Test Screen
Calibrate Calibrate Calibrate Screen Screen Screen 2 2 2
Calibrate Screen 2 initiates a volume test for the
selected pump. During the test, the Volume Check
screen will appear.
The pump and lines must be primed with a compound
(not solvent) before doing the Volume Check. See
Pump Volume Check, page 95 , for complete test
instructions.
To initiate the test, press the Volume Check
button for the desired pump.
The screen displays the volume dispensed. Press
to end the test.
Press and hold the Reset button for 1-2
seconds to reset the volume counter.
Figure 72 Calibrate Screen 2
Figure 73 Volume Check Screen
3A6287E 87